This is the best I could do to get bath tub drain system out to the wall of bath tub, while waiting for a solution from you all on which glue to buy. What glue should I use to stick the part A on the hole? This is how I stick part A on the bath tub:ģ) What screw, nut, bolt or other tool to hold part B to part A?Īny suggestion is welcomed! Let me know if you need more photos! Thank you.įurther investigation reveals that there is a bath tub drain system installed in this bath tub, as seen in the image below: However, by accident, I had pushed the screw into the inner part of bath tub.ġ) Would there be any problem if I left the screw inside the bath tub?Ģ) The part A is held on the bath tub wall by a glue. Take note that the white part of the part A would be glued to the bath tub wall Lastly, based on my best guess & screw type/size here is the back of the part A with screw. Here is the top view of part A with screw When I removed part B, there was a screw at the part A to hold the part B. Some tubs have separate stoppers and strainers, while others have combination stoppers and. The cap consists of 2 parts:Part A & B as below 1.Take out the stopper and/or strainer and remove any gunk. Unscrew the tub spout and tub overflow cover. Install the trim and your done, but if you run into trouble you can ask for help on the forum.I was cleaning the bath tub and I had unscrew a cap from the side of bath tub (where the hole is located) below: Beadboard Bathtub Yes, you can use wood for your DIY tub surround ideas, but youd need pressure-treated. After the plug is installed let the tub fill up and leak test the overflow.Leak test the drain outlet for a couple minutes before putting in the plug assembly. It also goes behind the tub and is drawn in tight to the tub by the screw or screws.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |